Settings; Schedule; Cutting Height - Husqvarna AUTOMOWER 535 AWD Operator's Manual

The product has factory settings but the settings can be
adapted to each work area.

4.1 Schedule

Schedule you can change the schedule settings for
In
the product.
The schedule function controls which hours the product
is permitted to operate. When the product does not
operate, it is parked in the charging station. You can
see which hours and days the product operates in the
schedule overview in the app.
The table shows the approximate number of hours the
product must operate each day for a specified area
dimension.
Area
2
500 m /
0.12 acre
2
1000 m /
0.25 acre
2
1500 m /
0.37 acre
2
2000 m /
0.5 acre
2
2500 m /
0.62 acre
There are 3 different quality levels that you can select
which decides the cutting frequency:
• Pro sport quality: Used for everyday care of sports
fields or golf courses at low cutting height. For a
well managed, lush and dense turf.
• Pro quality: For facilities with high demands on
grass quality. Medium grass height and normal
dense quality of turf. The grass is cut every second
day.
• Regular quality: For turf with low level of grass
growth. High cutting height and normal to low
dense quality of turf. The grass is cut two times
per week.
1427 - 009 - 20.12.2022

4 Settings

®
Automower 535 AWD
5 h
10 h
15 h
20 h
24 h
Quality
Pro sport quality
Pro quality
Regular quality
4.1.1 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to table
below.
3. The result is equal to the number of hours that the
product must operate each day.
Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
Schedule settings.
the
Model Approximate operation capaci-
2
ty, m
®
Automower 535 146 / 175
AWD
2
Example: A lawn of 500 m / 600 yd
Automower ® 535 AWD.
2
500 m / 146 ≈ 3.5 h.
2
600 yd / 175 ≈ 3.5 h.
Days / week h / day
7 3.5

4.2 Cutting height

4.2.1 Adjust the cutting height
The cutting height can be varied from MIN (3 cm / 1.2
in.) to MAX (7 cm / 2.8 in.).
Note:
During the first week after a new installation, the
cutting height must be set to MAX to avoid damaging the
loop wire. After this, the cutting height can be lowered
step by step every second week until the desired cutting
height has been reached.
Operation frequency
Each day
Each second day
Each third day
2 2
/ yd .
2
/ yd / h
2
, cut with an
Schedule settings
10:00 - 13:30 / 10 am -
1.30 pm
Settings - 21