Settings; Schedule; Cutting Height; Operation - Husqvarna AUTOMOWER 435X AWD Operator's Manual

The product has factory settings but the settings can be
adapted to each work area.

4.1 Schedule

Schedule you can change the schedule settings for
In
the product.
Schedule function controls which hours the product
The
operates. When the product does not operate, it is
parked in the charging station. You can see which hours
and days the product operates in the schedule overview
in the app.
You can set the Schedule if the work area is less
than the maximum area capacity of the product. This
prevents wear on the grass and the product. The factory
schedule setting lets the product to operate around the
clock 7 days a week.
To calculate the schedule setting, refer to
the schedule setting on page 23 .
4.1.1 To calculate the schedule setting
1. Calculate the dimension of your lawn in m
2 2
2. Divide the m / yd of the lawn with the
approximate operation capacity. Refer to table
below.
3. The result is equal to the number of hours that the
product must operate each day.
Note:
The operation capacity is approximate and is
calculated for flat and open work area. If the work area
has a lot of slopes or obstacles, you need to increase
Schedule settings.
the
Model Approximate operation capaci-
ty, m 2
Automower ® 435X 146 / 175
AWD
2
Example: A lawn of 500 m / 600 yd
®
Automower 435X AWD.
2
500 m / 146 ≈ 3.5 h.
2
600 yd / 175 ≈ 3.5 h.
Days / week h / day
7 3.5
1404 - 013 - 20.12.2022

4 Settings

To calculate
2 2
/ yd .
/ yd 2 / h
2
, cut with an
Schedule settings
10:00 - 13:30 / 10 am -
1.30 pm

4.2 Cutting height

4.2.1 Adjust the cutting height
The cutting height can be varied from MIN (3 cm / 1.2
in.) to MAX (7 cm / 2.8 in.).
Note:
During the first week after a new installation, the
cutting height must be set to MAX to avoid damaging the
loop wire. After this, the cutting height can be lowered
step by step every second week until the desired cutting
height has been reached.
4.2.2 TargetHeight
Use the TargetHeight function to lower the cutting height
from MAX to the specified cutting height gradually during
10 days. If you change the cutting height manually
during this time it will disable the TargetHeight function.

4.3 Operation

In Operation you can change the operation settings of
the product.
4.3.1 Object avoidance
Object avoidance function makes the product
The
decrease speed when it comes near an obstacle to
avoid to collide with it.
Note:
This can cause that the grass is not cut around
the obstacle. This function can cause the product to not
cut high grass satisfactorily.
4.3.2 Weather timer
Weather timer automatically adjust the cutting time to
the growth of the grass. The product is not permitted to
operate more than the schedule settings.
Note:
Weather timer , it is recommended
When using
to make as much operating time as possible available
Weather timer . Do not restrict the schedule more
for
than necessary.
Settings - 23