Table of Contents
Advertisement
21. Re-install larger front spacer and key onto
arbor. Arbor should look like arbor shown in
Figure 143.
Spacer
Key
Figure 143. Components re-installed on arbor.
22. Lift motor to its maximum elevation, then
secure motor adjustment bolt.
23. Place belt onto bottom motor pulley, then
wrap belt around arbor housing bracket
above it.
24. Place arbor pulley between arbor housing
brackets, slide belt over pulley, then insert
arbor into pulley, as shown in Figure 144.
Arbor
Housing
Brackets
Figure 144. Re-installing arbor and belt.
25. Tap arbor shaft into pulley, making sure shaft
is straight.
26. Install rear spacer onto end of arbor.
-80-
Bearing
Arbor Pulley
Belt
Arbor
27. Use block of wood to seat new 6203-2RS
bearing (PN# P1023RL100) into end of arbor.
28. Thread lock nut onto arbor shaft, place open
end of arbor wrench on arbor, and use 25mm
wrench to tighten nut so it is snug, but not too
tight.
29. Re-install bearing retainer with (3) Phillips
head screws removed earlier.
30. Tighten pulley set screws shown in Figure
138 on Page 79.
31. Check position of belt on pulley sheaths;
adjust if necessary so it is centered.
32. Tension belt (refer to Tensioning Belt on
Page 77).
33. Re-install mounting plate and dust chute with
cap screws removed in Step 7.
34. Replace shims at locations from which they
came.
35. With help from an assistant, lift table and
place it on top of cabinet. Align mounting
holes in table and cabinet, then secure table
with mounting bolts.
36. Re-install table insert and close motor cover.
37. Verify that blade and miter slot are parallel
at 90° and 45° (refer to instructions on Page
67).
38. Raise blade all the way up, then tilt blade to
45°.
— If blade does not touch insert, no further
adjustments need to be made.
— If blade does touch insert, loosen table
mounting bolts, adjust table until blade
does not touch insert, then tighten mount-
ing bolts. Re-check miter slot to blade
parallelism and adjust as needed.
Model G1023RL Series (Mfd. Since 02/21)
Advertisement
Table of Contents
