Table of Contents
Advertisement
12. Loosen set screws shown in Figure 138.
Figure 138. Location of arbor set screws.
13. Use punch and hammer to drive arbor out, as
shown in Figure 139. Have another person
catch arbor so it does not drop and become
damaged.
Figure 139. Removing arbor.
14. Pivot motor up, tighten motor bolt, then
remove belt from top and bottom pulleys.
15. Remove rear spacer from bearing housing
(see Figure 140).
Rear
Spacer
Figure 140. Location of rear spacer.
Model G1023RL Series (Mfd. Since 02/21)
Set Screws
16. Tap rear arbor bearing out; make sure anoth-
er person catches bearing.
17. Remove key and larger front spacer from
arbor and set these aside.
18. Place arbor in a vise, as shown in Figure
141, with vise teeth clamping bearing, then
use a soft rubber hammer to force arbor out
of bearing.
Arbor
Figure 141. Removing arbor bearing.
19. Slide new 6203-2RS ball bearing (PN#
P1023RL100), onto arbor shaft, then place
arbor between vise teeth, as shown in Figure
142.
Arbor
Figure 142. Seating arbor into new bearing.
20. Using rubber hammer, seat arbor onto bearing
(see Figure 142), then remove it from vise.
Bearing
Bearing
-79-
Advertisement
Table of Contents
