Table of Contents
Advertisement
5.
Rotate marked blade tip to other end of table
insert.
6.
Compare distance from marked blade tip to
miter slot, as shown in Figure 111.
STEP B
Blade tilted to 90º
Front
Figure 111. Measuring distance from miter slot
to carbide tip on opposite side of table insert.
— If distance between blade tip and miter
slot is not the same on both sides of table
insert, table will need to be adjusted.
Proceed to Step 7.
— If blade tip measurement is the same on
both sides, go to Step 8.
7.
To adjust table, loosen (4) bolts in table
mounting locations (see Figure 112) and
lightly tap table in direction needed to square
table to blade. Repeat Steps 3–6 until blade
and miter slot are parallel. Do not forget to
tighten table mounting bolts when finished.
Mounting
Locations
Figure 112. Table mounting bolt holes (table top
removed for clarity).
-68-
B
Table
8.
Tilt blade to 45° and repeat Steps 3–6.
— If blade is still parallel with miter slot no
further adjustments need to be made. Go
to Blade Alignment.
— If blade was parallel with miter slot at 90°
but not at 45°, one end of table will need to
be shimmed higher with metal shim stock.
9.
Loosen four table mounting bolts.
10. Refer to Figures 113–114 for shim place-
ment. If distance of A is shorter than B,
shim(s) will need to be placed under corners
#1 and #2. If distance of B is shorter than A,
shim(s) will need to be placed under corners
#3 and #4. Very thin shim stock works well.
STEP A
#1
Front
#2
Figure 113. Shim procedure diagram A.
STEP B
#1
Front
#2
Figure 114. Shim procedure diagram B.
Model G1023RL Series (Mfd. Since 02/21)
#3
#4
#3
#4
Advertisement
Table of Contents
