Table of Contents
Advertisement
Replacing Belt
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove table insert.
Remove ON/OFF switch from table.
3.
Remove four table mounting bolts.
4.
5.
With help of an another person, lift table off of
cabinet and set it aside.
Note location and quantity of any shims on
6.
cabinet top, then set them aside.
Remove cap screws that secure dust collec-
7.
tion chute, shown in Figure 134, then remove
chute.
Dust
Collection
Screws
Chute
Figure 134. Dust chute mounting screws.
8.
Remove cap screws that secure mounting
plate shown in Figure 135, then remove
plate.
Cap Screws
Figure 135. Removing mounting plate.
-78-
Cap
Mounting
Plate
9.
Loosen motor adjustment bolt (see Figure
132 on Page 77).
10. Remove (3) Phillips head screws on bearing
retainer, shown in Figure 136, then remove
retainer.
Phillips
Head
Screw
Figure 136. Removing bearing shield.
11. Place open end of arbor wrench on arbor, and
while keeping arbor stationary, use a 25mm
wrench to loosen and remove lock nut at other
end of arbor, as shown in Figure 137.
Figure 137. Removing arbor lock nut. (Inset:
arbor lock nut.)
Model G1023RL Series (Mfd. Since 02/21)
Bearing
Retainer
Advertisement
Table of Contents
