3. Wipe off water and neutral deter-
gent.
4. Lubricate with a motorcycle sealed
drive chain lubricant or high viscosity
oil (#80 – 90).
NOTICE
Some drive chain lubricant contains
solvents and additives which could
damage the seal rings in the drive
chain.
Use sealed drive chain lubricant,
which is specifically intended for use
with sealed drive chains.
5. Lubricate both front and back plates
of the drive chain.
6. Wipe off excess lubricant after lubri-
cating all around the drive chain.
DRIVE CHAIN ADJUSTMENT
Inspect the drive chain slack before
each use of the motorcycle. Place the
motorcycle on the side stand. The drive
chain should be adjusted for 0.8 – 1.2 in
(20 – 30 mm) of slack, as shown.
3-55
0.8 – 1.2 in
(20 – 30 mm)