Table of Contents
Advertisement
Super X13SEW-TF/-F User's Manual
NC-SI Header for BMC Support
A Network-Controller Sideband Interface (NC-SI) header is located at JNCSI1 on the motherboard.
For remote management, connect the appropriate cable from this header to an add-on card to
provide the out-of-band (sideband) connection between the onboard Baseboard Management
Controller (BMC) and a Network Interface Controller (NIC). For the network sideband interface
to work properly, you will need to use a NIC add-on card that supports NC-SI and must use a
special cable. Contact Supermicro at
Note: For detailed instructions on how to configure Network Interface Card (NIC) set-
tings, refer to the Network Interface Card Configuration User's Guide posted on the
web page under the link: http://www.supermicro.com/support/manuals/.
Power SMB (I
C) Header
2
Power System Management Bus (I
system temperatures. Refer to the table below for pin definitions.
JUIDB1
VGA
MH1
BMC
BT1
CMOS CLEAR
MH15
MH6
MH9
MH10
FAN3
FAN6
FAN5
FAN4
www.supermicro.com
C) header at JPI2C monitors the power supply, fan and
2
Power SMB Header
Pin Definitions
Pin#
Definition
1
Clock
2
Data
3
Power Fail
4
Ground
5
+3.3V
COM1
MH2
USB3/4
(3.2 Gen 1)
1
LAN2
LAN1
IPMI_LAN
USB0/1
JNCSI1
JPFR2
JTPM
X550
MH4
MH17
M.2 NVME
JBT1
M.2-P
USB2
PCH
C741
JRK1
MAC CODE
SAN MAC
2
BIOS LICENSE
JVRM1
CPU
JPI2C
MH8
FAN2
FAN1
MH7
to purchase the cable for this header.
1. NC-SI Header
2. Power SMB (I²C) Header
50
Advertisement
Table of Contents
