Supermicro X13SEW-TF User Manual page 102

Table of Contents

Advertisement

Super X13SEW-TF/-F User's Manual
MMCFG Base
This feature determines how the lowest Memory Mapped Configuration (MMCFG) base is
assigned to onboard PCI devices. The options are 1G, 1.5G, 1.75G, 2G, 2.25G, 3G, and Auto.
MMCFG Size
Use this feature to set the MMCFG size. The options are 64 M, 128 M, 256 M, 512 M, 1G,
2G, and Auto.
MMIO High Base
Use this feature to select the base memory size according to memory-address mapping for
the IO hub. The options are 56T, 40T, 32T, 24T, 16T, 4T, 2T, 1T, 512 G, and 3584T.
MMIO High Granularity Size
Use this feature to select the high memory size according to memory-address mapping for
the IO hub. The options are 1G, 4G, 16G, 64G, 256G, and 1024G.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization Support. The options are
Disabled and Enabled.
ARI Support
Use this feature to enable or disable ARI support. The options are Disabled and Enabled.
Bus Master Enable
If this setting is set to Enabled, the PCI Bus Driver will enable the Bus Master Attribute for
DMA transactions. If this setting is set to Disabled, the PCI Bus Driver will disable the Bus
Master Attribute for Pre-Boot DMA protection. The options are Disabled and Enabled.
NVMe Firmware Source
Use this feature to select the NVMe firmware to support booting. The default option, Vendor
Defined Firmware, is pre-installed on the drive and may resolve errata or enable innovative
functions for the drive. The other option, AMI Native Support, is offered by the BIOS with a
generic method. The options are Vendor Defined Firmware and AMI Native Support.
VGA Priority
Use this feature to select the graphics device to be used as the primary video display for
system boot. The options are Onboard and Offboard.
For the following features, note that:
Note 1: The number of slots and slot naming vary based on your motherboard.
Note 2: The Legacy option is available when "Boot Mode Select" is set to Dual.
Note 3: Refer to Boot submenu in BIOS Setup main menu to set "Boot Mode Select."
102

Advertisement

Table of Contents
loading

This manual is also suitable for:

X13sew-fX13sew-tf-f

Table of Contents