Table of Contents
Advertisement
USB Security Policy
Use this feature to configure USB Security Policy settings. When this feature has not
previously been set to Enabled, this feature will toggle whether the BIOS should automatically
save a USB Authentication-Key named "USBAuth.bin" to a USB flash drive and begin the
USB Security Policy. The options are Disabled and Enabled. Changes take effect after you
save settings and reboot the system.
Note: Connect a USB flash drive to your system before configuring this feature. Save
the USB Authentication-Key and keep a backup.
When this feature has been previously set to Enabled, the options are Enabled and
Reset. To disable the USB Security Policy, set this feature to Reset. When this feature is
set to reset, the system and TCG NVMe devices chosen in "Super-Guardians Protection
Policy" will be in the unprotected mode.
Intel(R) I210 Gigabit Network Connection - xx:xx:xx:xx:xx:xx
Intel(R) I210 Gigabit Network Connection - xx:xx:xx:xx:xx:xx
Note 1: This feature is available when "Onboard LAN Option ROM Type" is set to EFI.
Note 2: The Ethernet controller and MAC addresses shown above are based on your
system.
Firmware Image Properties
The following information is displayed:
•
Option ROM Version
•
Unique NVM/EEPROM ID
•
NVM Version
NIC Configuration
Link Speed
This feature displays the connection speed of a LAN port. The options are Auto Negotiated,
10 Mbps Half, 10 Mbps Full, 100 Mbps Half, and 100 Mbps Full.
Wake On LAN
If this feature is set to Enabled, the LAN port you specified will be enabled when the system
is powered on. The options are Disabled and Enabled.
107
Chapter 4: UEFI BIOS
Advertisement
Table of Contents
