Table of Contents
Advertisement
•
Starting point (C). Refer to
on page 22 .
•
Minimum distance 60 cm / 2 ft. from the starting
point to perpendicular to the boundary wire (D).
Support on page 6 .
Refer to
•
Minimum distance 60 cm / 2 ft. perpendicular to the
guide wire (D).
•
Where the guide wire is connected to the boundary
wire (E).
•
Guide corridor (F). The product always runs to the
left of the guide wire as seen facing the charging
station. Make sure that the guide wire has as much
free area as possible to the left of the guide wire.
The guide corridor can be maximum 1.2 m / 4 ft.
Note:
The product always runs in the guide
corridor but changes the distance to the guide
wire.
•
Do not make sharp bends when you install the
guide wire.
135º
3.4.5 Work area examples
•
If the charging station is put in a small area (A),
make sure that the distance to the boundary wire is
at a minimum 2 m / 6.6 ft. in front of the charging
station.
•
If the work area has a passage (B) with no guide
wire installed, the minimum distance between the
boundary wires is 2 m / 6.5 ft. With a guide
wire installed through the passage, the minimum
distance between the boundary wires is 60 cm / 24
in.
•
If the work area has areas which are connected
by a narrow passage (B), you can set the product
to first follow and then leave the guide wire
after a certain distance (C). The settings can
Lawn Coverage and Systematic
be changed in
Passage Mowing on page 22 .
•
If the work area includes a secondary area
Secondary area on page 24 . Put
(D), refer to
the product in the secondary area and select
Secondary area mode .
1886 - 001 - 01.02.2023
To set the starting point
90º
135º
3.5 Installation of the product
3.5.1 Installation tools
•
Hammer/plastic mallet: To simplify putting the
stakes into the ground.
•
Edge cutter/straight spade: To bury the boundary
wire.
•
Combination pliers: For cutting the boundary wire
and pressing the connectors together.
•
Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
CAUTION:
the charging station plate.
CAUTION:
baseplate of the charging station.
WARNING:
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
D
A
B
C
Do not make new holes in
Do not put your feet on the
Make sure that the plugs of
Installation - 17
Advertisement
Table of Contents
