Table of Contents
Advertisement
8.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
•
Obey all applicable national regulations.
•
Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
8.2 To put the product into storage
•
Fully charge the product. Refer to
battery on page 26 .
•
Set the product to OFF. Refer to
to OFF on page 26 .
•
Clean the product. Refer to
page 29 .
•
Keep the product in a dry, frost free space.
•
Keep the product with all wheels on level ground
or hang it on the wall with the storage hook. Refer
To install the storage hook on the wall on page
to
41 .
•
If you keep the charging station indoors,
disconnect and remove the power supply and
all the connectors from the charging station. Put
the end of each connector wire in a connector
protection box.
Note:
If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
•
Speak to your Husqvarna service for information
about available storage accessories for your
product.
8.2.1 To install the storage hook on the wall
•
Install the storage hook indoors.
•
Keep the storage hook out of sunlight.
•
Install the storage hook on a drywall, wood or
concrete wall.
CAUTION:
wall can hold loads of minimum 30 kg.
•
Remove the drill template from the carton of the
product to use it to install the storage hook on the
wall.
•
Install the storage hook on the wall with the 3
screws (A). Use wall plugs (B) if it is necessary.
1886 - 001 - 01.02.2023
8 Transportation, storage and disposal
To charge the
To set the product
Clean the product on
Make sure that the
A
CAUTION:
screws are applicable for your wall
type.
•
Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
8.3 Disposal
•
Obey the local recycling requirements and
applicable regulations.
CAUTION:
when you dispose the product. The
Husqvarna warranty is not applicable if you
remove the warranty seal.
8.3.1 To remove the battery
WARNING:
CAUTION:
boards.
1.
Push the ON/OFF button for 3 seconds to switch
off the product.
2.
Make sure that the product is disabled. The
indicator lamp on the ON/OFF button is not
on when the product is disabled. Refer to
indicator on the keypad on page 9 .
3.
Put the product with the blade disc up.
4.
Remove the 10 screws with a Torx 20.
B
Make sure that the
Only remove the battery
Use protective gloves.
Do not touch the circuit
LED
Transportation, storage
and disposal - 41
Advertisement
Table of Contents
