Table of Contents
Advertisement
60- cm / 24- in.
•
Put the charging station near a power outlet.
•
Put the charging station on a level surface.
•
The baseplate of the charging station must not be
bent.
Max 3 cm/1.2"
Max 3 cm/1.2"
Max +/- 2 cm / 0.8 in.
•
If the work area has two parts separated with a
steep slope, we recommend to put the charging
station in the lower section.
•
Put the charging station in an area with protection
from the sun.
•
Put the charging station where there is Wi-Fi
coverage to download new firmware. Refer to
Download firmware over the air (Firmware over the
air FOTA) on page 23 .
•
If the charging station is installed on an island,
make sure to connect the guide wire to the island.
Mowing technique on page 6 .
Refer to
1886 - 001 - 01.02.2023
3.4.2 To examine where to put the power
supply
WARNING:
the low-voltage cable. There is a risk of
electrical shock.
CAUTION:
on the product do not cut the low-voltage
cable.
CAUTION:
cable in a coil or below the charging station
plate. The coil causes interference with the
signal from the charging station.
•
Put the power supply in an area with a roof and
protection from the sun and rain.
•
Put the power supply in an area with good airflow.
•
Use a residual-current device (RCD) with a tripping
current of maximum 30 mA when you connect the
power supply to the power outlet.
Low-voltage cables of different lengths are available as
accessories.
3.4.3 To examine where to put the
boundary wire
CAUTION:
minimum 15 cm / 6 in. in height between
the boundary wire and water bodies, slopes,
precipices or public roads. This will prevent
damage to the product.
Do not cut or extend
Make sure that the blades
Do not put the low-voltage
There must be a barrier of
Installation - 13
Advertisement
Table of Contents
