Table of Contents
Advertisement
To prepare
Last step
Use a software service tool to do a function test of the functions of the product.
6.3 Clean the product
CAUTION:
washer to clean the product. Do not use
solvents for cleaning.
Husqvarna recommends to use a special cleaning and
maintenance kit. Speak to your Husqvarna service for
more information.
6.3.1 To clean the chassis and blade disc
Examine the blade discs and blades weekly. Remove
the body of the product to clean it fully.
1.
Push the STOP button.
2.
Push the ON/OFF button for 3 seconds to set the
product to OFF. Make sure that the LED indicator
on the keypad goes out.
3.
Lift the top cover by the front and remove it.
4.
Remove the maintenance tool from the body of the
product.
5.
Hold the rear wheel with one hand.
6.
Push the back of the hand up to lift the body of the
product.
1886 - 001 - 01.02.2023
Do not use a high-pressure
B
A
Weekly
7.
With your other hand, push the left clip (A) and
then the right clip (B).
Note:
You cannot see the clip (A) and (B). You
find the clips in the hole at the front of the product.
8.
Push the maintenance tool into the 2 holes to
loosen the body of the product.
9.
Remove the body of the product.
10. Put the product onto its side.
11. Make sure that the blades are not damaged and
that the blades and blade discs can rotate freely.
12. Clean the blade discs and chassis with a brush
and running water.
6.3.2 To clean the wheels
The product does not operate satisfactorily in slopes if
the wheels are blocked with grass.
•
Use a soft brush to clean the wheels.
6.3.3 To clean the body of the product
•
Use a moist cloth and a weak soap solution to
clean the body of the product.
6.3.4 To clean the charging plates and
contact plates
1.
Use a fine grade emery cloth to clean the charging
plates and the contact plates.
2.
Lubricate the charging plates and contact plates
with oil or grease.
Every
Every
year
third year
O
Maintenance - 29
Advertisement
Table of Contents
