Table of Contents
Advertisement
4.3 Installation
Installation you can change the installation settings of
In
the product.
4.3.1 Lawn Coverage and Systematic
Passage Mowing
If the work area includes remote parts that are
connected with narrow passages, the
Systematic Passage Mowing function are useful to
and
be able to maintain a well-cut lawn in all parts of the
Lawn Coverage function is used to guide
yard. The
the product to remote parts of the work area. The
Systematic Passage Mowing function is used for narrow
passage mowing. A guide wire must be installed to use
these functions. You can set a maximum of 3 remote
areas.
Lawn Coverage function the product first
With the
follows and then leaves the guide wire after a certain
distance and starts to mow the lawn.
Systematic Passage Mowing function is suitable
The
to mow narrow passages of 60 cm - 1.5 m / 2 in. -
4.9 ft. width. The product moves in a pattern to cover
the passage width. The product starts the
Passage Mowing at the set distance from the charging
station. When the product reaches the end of the narrow
passage, the product continues and cuts the lawn as
normal.
Area A, approximately 50%
Area B, approximately 30%
Area C, approximately 20%
A
9
Available as accessory
22 - Settings
4.3.2 To set the starting point
The product starts to operate at the starting point. The
starting point is set to control how far the product
moves along the guide wire from the charging station.
The product straddles the guide wire from the charging
station to the starting point. The factory setting is 60 cm /
2 ft.
•
•
Lawn Coverage
4.3.3 Drive Past Wire function
The front of the product always moves past the
Systematic
boundary wire by a specified distance. Then the product
moves rearward and changes direction. The factory
setting is 32 cm / 12 in. You can select a distance of
20-35 cm / 8-14 in.
Note:
the distance will change along the boundary wire in all
parts of the work area.
4.4 Accessories
C
In
product accessories.
4.4.1 Avoid collisions with Husqvarna
mower house
B
If you have installed a Husqvarna mower house
wear on the product and the mower house decreases
when you select
setting this function is disabled.
Set the starting point at a short distance from the
charging station to prevent tracks on the lawn.
If the charging station is put in a small area, set the
starting point (A) where the minimum distance (B)
to the boundary wire is 60 cm / 2 ft.
A
B
If you change the distance for
Accessories you can change the settings of the
Avoid house collisions . In the factory
Drive Past Wire ,
9
, the
1886 - 001 - 01.02.2023
Advertisement
Table of Contents
