Installation Of The Product - Husqvarna AUTOMOWER 320 NERA Operator's Manual

ft. With a guide wire installed through the passage,
the recommended minimum distance between the
boundary wires is 60 cm / 24 in.
• If the work area has areas which are connected by
a narrow passage (B), you can set the product to
first follow and then leave the guide wire after a
certain distance (C). The settings can be changed
GPS assisted navigation on page 22 .
in
• Use the GPS Assisted Navigation that helps the
product select the most optimal operation. Refer to
Lawn coverage on page 22 .
• If the work area includes a secondary area (D),
To make a secondary area on page 15 .
refer to
Put the product in the secondary area and select
Secondary area mode .

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the product
Do the general steps that follow to install the product:
16 - Installation
D
A
B
C
1. Install the Automower
mobile device. Refer to
on page 16 .
2. Do a pairing operation of the product and the
®
Automower Connect app. Do the basic settings in
the start up sequence in the Automower
To install the Automower
app. Refer to
app on page 17 .
3. Install the charging station. Refer to
charging station on page 17 .
4. Install the boundary wire. Refer to
boundary wire on page 18 .
5. Install the guide wire. Refer to
wire on page 18 .
6. Make sure that the charging station is installed
correctly. Refer to
charging station on page 19 .
®
3.5.3 Automower
The product can connect to mobile devices that have
®
the Automower Connect app installed. Automower
Connect is a free app for your mobile device. You
can use the extended functions for the product in the
®
Automower Connect app.
Dashboard shows the current operation of the
• The
product. You can select an operating mode for the
product in the dashboard.
Map shows the current position of the product
• The
and the set center point for the GeoFence function.
Settings menu you can set the settings for
• In the
the product.
Statistics menu you can see the statistics of
• In the
the product.
Messages menu you can find the Fault
• In the
messages and the Information messages of the
product.
Support menu you can find the full operator's
• In the
manual for the product and the
you can get help with troubleshooting.
®
Connect app on your
®
Automower Connect app
®
®
Connect
To install the
To install the
To install the guide
To do a visual check of the
Connect app
Help Center where
2071 - 001 - 29.03.2023
Connect
®