Table of Contents
Advertisement
7.3 Information and warning messages
The information messages in the table below are shown in the app. Speak to your Husqvarna service if the same
message shows frequently.
Message
Settings restored
FlexiFence problem
Guide not found
Loop signal created
Needs manual charging
Next start hh:mm
Today's mowing comple-
ted
Connection NOT changed
36 - Troubleshooting
Cause
Reset all user settings has been done.
A
The battery of the FlexiFence accessory
is low. The FlexiFence does not operate
when the battery is empty. The product
can cut in the stay-out zone if you start the
product before you charge the FlexiFence.
The temperature in the FlexiFence acces-
sory is a higher than the maximum limit
and is set to off.
The guide wire is not connected to the
charging station.
Damage in the guide wire.
The guide wire is not connected to the
boundary loop.
New loop signal changed.
The product is set to the
operating mode.
The schedule setting prevents the product
from operating.
The product has operated the maximum
cutting time for the day.
The product has operated the maximum
cutting time for the day.
The loop signal was not changed because
of an error.
Action
Usual operation of the product.
Park the product and charge the Flex-
iFence accessory before you start the
product.
Put the product in an area with protec-
tion from the sun. Let the temperature of
the FlexiFence accessory decrease before
you start the product.
Connect the guide wire to the charging
station. Refer to
on page 18 .
Replace the damaged section with new
guide wire.
Connect the guide wire correctly to the
boundary loop. Refer to
guide wire on page 18 .
Usual operation of the product.
Secondary area
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 21 .
Usual operation of the product.
Usual operation of the product. Refer to
Schedule on page 21 .
Make a
times. Refer to
23 . If the problem stays speak to your
Husqvarna service.
To install the guide wire
To install the
New loop signal a number of
New loop signal on page
1886 - 001 - 01.02.2023
Advertisement
Table of Contents
