Installation Of The Product - Husqvarna Automower 520 Operator's Manual

D
B
®
3.4.6 Automower Club Solution
®
Automower Club Solution makes it possible to use
2 or 3 products in one installation. It requires special
configuration in the product and the installation of the
boundary wires and charging stations is different. To
®
use Automower Club Solution, speak to your local
Husqvarna representative.
The installation of the boundary wire and charging
stations must be made in parallel. Maximum width of the
work area is 70 m / 230 ft.
The changes when using the Automower
configuration are:
• The product follows the boundary wire clockwise to
find the charging station.
• You cannot use guide cables.
• You cannot use the Park button.
• The blade disc speed and noise level increases.
18 - Installation

3.5 Installation of the product

3.5.1 Installation tools
• Hammer/plastic mallet: To simplify putting the
stakes into the ground.
• Edge cutter/straight spade: To bury the boundary
wire.
• Combination pliers: For cutting the boundary wire
A
and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
3.5.2 To install the charging station
C
When connecting the power supply, only use a power
outlet that is connected to a residual-current device
(RCD).
1. Read and understand the instructions about where
to put the charging station. Refer to
where to put the charging station on page 13 .
2. Put the charging station in the selected area.
Note:
the screws to the ground until the guide wire is
installed. Refer to
19 .
3. Connect the low-voltage cable to the charging
station.
4. Put the power supply at a minimum height of 30
® Club Solution
cm / 12 in.
CAUTION:
Do not make new holes in
the charging station plate.
CAUTION:
Do not put your feet on the
baseplate of the charging station.
WARNING:
The power supply cable
and extension cable must be outside the
work area to avoid damage to the cables.
WARNING:
Make sure that the plugs of
the low-voltage cable and the power supply
unit are clean and dry before you connect
them.
Do not attach the charging station with
To install the guide wire on page
1439 - 015 - 23.11.2022
To examine