Shutting Down The Projector - BenQ W1140 User Manual

Once detected, the picture from the selected source will appear. If there is multiple equipment
connected to the projector, repeat steps 1-2 to search for another signal.
• The brightness level of the projected image will change accordingly when you switch between different input
signals.
• For best display picture results, you should select and use an input signal which outputs at the projector's native
resolution. Any other resolutions will be scaled by the projector depending upon the "aspect ratio" setting,
which may cause some image distortion or loss of picture clarity. See

Shutting down the projector

1. Press on the projector or remote control
confirmation message will appear prompting you. If you
don't respond in a few seconds, the message will
disappear.
2. Press on the projector or remote control
second time. The power indicator flashes orange, the
projection light source shuts down, and the fans will
continue to run for approximately 2 seconds to cool
down the projector.
3. Once the cooling process finishes, the power indicator
becomes a steady orange and fans stop. Disconnect the power cord from the power outlet.
To protect the light source, the projector will not respond to any commands during the cooling process.
Aspect Ratio on page
and a
a
33.
Operation 23