Table of Contents
Advertisement
Entering the password recall procedure
1. Press and hold OK for 3 seconds. The projector will
display a coded number on the screen.
2. Write down the number and turn off your projector.
3. Seek help from the local BenQ service center to decode
the number. You may be required to provide proof of
purchase documentation to verify that you are an
authorized user of the projector.
Changing the password
1. Go to Advanced menu - System > Security Settings. Press OK. The Security Settings page
appears.
2. Highlight Change Password and press OK.
3. Enter the old password.
• If the password is correct, another message Input New Password appears.
• If the password is incorrect, the password error message will appear, and the message INPUT
CURRENT PASSWORD appears for your retry. You can press BACK to cancel the change or
try another password.
4. Enter a new password.
5. Confirm the new password by re-entering the new password.
Disabling the password function
To disable password protection, go to Advanced menu - System > Security Settings > Power On
Lock, press OK and
password.
• If the password is correct, the OSD menu returns to the Security Settings page. You will not
have to enter the password next time turning on the projector.
• If the password is incorrect, the password error message will appear, and the message INPUT
CURRENT PASSWORD appears for your retry. You can press BACK to cancel the change or
try another password.
Though the password function is disabled, you need to keep the old password in hand should you ever need to
re-activate the password function by entering the old password.
Switching input signal
The projector can be connected to multiple devices at the
same time. However, it can only display one full screen at a
time. When starting up, the projector automatically searches
for the available signals.
Be sure the Advanced menu - Display > Auto Source
Search is On if you want the projector to automatically
search for the signals.
To manually select the source:
1. Press SOURCE. A source selection bar appears.
2. Press
/ until your desired signal is selected and press OK.
22
Operation
/ to select Off. The message Input Password appears. Enter the current
Recall Password
Please write down the recall code, and
contact BenQ Customer Center.
Recall Code:
CJ-2014-541638
Return
Source
HDMI-1
HDMI-2
Advertisement
Table of Contents
