Local Access Connections; To Connect The Pc To The Rad - Nortel Meridian Companion PCI User Manual

Local access connections

Figure 1: Overview of CDS local connections and wireless system
Companion 200
Meridian Companion
Public
Switch
or
PBX
Public
Switch
or
PBX
Access
Lines

To connect the PC to the RAD

P0886303 Issue 01 Standard
Figure 1 shows the connections that you must make to examine a
wireless system using CDS at the customer site. Refer to the Remote
Access Device Installation Guide if you require more detail on RAD
hardware connections or programming.
TCM
Lines
Controller
RAD
TCM
Cable
1. Connect one end of the RS232 cable to serial port 1 or 2 on the
PC using a connector that matches your PC's port.
2. Place the PC within 100 feet (30 meters) of the RAD.
3. Connect the other end of the RS232 cable to the serial port on the
RAD using a female 25-pin connector or 9-pin connector as
required.
To connect the RAD to the Controller:
1. Connect one end of the RAD TCM cable to the RJ-11 port on the
back of the RAD using the RJ-11 connector.
Companion Diagnostic Software basics 9
Base Stations Portables
Distribution Administration
Block Terminal (M7310)
RS232 Cable
(max. 100 ft)
RAD
Companion Diagnostic Software for PCI User Guide
Companion
Diagnostic
Software
PC
Keyboard
CDS Application