Nortel Meridian Companion PCI User Manual page 116

Appendix B 111
Description This warning occurs when a radio resets fewer then
four times. If the reset count is greater than four, an alarm is
generated. The six types of radio resets that produce this warning are
described below.
Action The action taken depends on the source of the radio reset.
Each radio reset type with a count greater than zero should be
checked in the following list, and the action corresponding to that
reset type should be taken.
Warning C221 actions
RR:<RIM reset count>
RIM Reset—A spontaneous reset of the radio's RIM has occurred.
Power fluctuations, high static discharges or intermittent hardware
failure may be responsible. If this problem persists, an alarm will be
generated, signifying a problem that should be attended to at that
time.
SCL:<SCL fault count>
SCL Fault—A failure in communication between the RIM and the
Line Interface Module (LIM) has occurred. An intermittent or
complete failure of hardware, such as the internal connector between
the RIM and the LIM, may be responsible. If this problem persists,
an alarm will be generated, signifying a problem that should be fixed
at that time.
Mem:<memory fault count>
A problem reading or writing RIM memory exists. An intermittent
problem, such as static discharge, or complete hardware failure may
be responsible. If this problem persists, an alarm will be generated,
signifying a problem that should be fixed at that time.
SF:<sanity failure count>
A RIM or LIM software problem is most likely. Disconnect and then
reconnect the power to the Base Station to ensure that the software
load is not corrupt. If this problem persists, an alarm will be
generated, signifying a problem that should be fixed at that time.
SS:<Station Set reset count>
A problem exists either within the controller or with the hardware
connection between the Base Station and the controller. If there is a
fault with the hardware connection between the Base Station and the
controller, it should also show up in the Synch Failure or Lost
P0886303 Issue 01 Standard Companion Diagnostic Software for PCI User Guide