Performing Upgrades - Nortel Remote Gateway 9110 Release Note

Standard 1.0

Performing upgrades

For complete details on performing upgrades, refer to the appropriate
Installation and Administration Guide for your specific product.
ATTENTION
Nortel recommends that you perform a firmware upgrade if you are using older
versions of firmware (release 1.3.4.x or earlier). To check the version of
firmware you are using, do one of the following:
If you are not connected to the device, open Configuration Manager and
connect to the Remote Gateway 9100 Series unit. A window displays the
RLC or Remote Gateway 9100 Series unit firmware version.
If you are already connected to the device, choose System Information
System Data. The unit firmware version displays.
WARNING
14
The protocol for communication between the RLC and the
Remote Gateway 9100 Series units requires that they be
running the same version of firmware for them to
communicate with each other.
To eliminate any confusion in board numbering, the RLC
automatically sets its Unit ID to 254 with this release when
upgrading from releases prior to 1.2.0.
The RLC now identifies the Remote Gateway 9100 Series
units by their Unit ID, not by their Unit Number or Node Name.
If the Unit ID is not the same as the Unit Number in the
Remote Connection Configuration on the RLC, the Unit ID in
the 9150 or 911x System Configuration sheet must be
changed to match the Unit Number.
To maintain compatibility with all installations that support a
single Remote Gateway 9100 Series unit, the upgrade
process assigns the default Unit ID of "1" to each unit to match
the default at the RLC. Following an upgrade, administrators
responsible for multiple Remote Gateway 9100 Series units on
a single RLC must configure the correct Unit ID at each
Remote Gateway 9100 Series unit.
1.6.0 Release Notes for Remote Gateway 9100 Series and RLC
→