Camera Block Assembly - Sony EVI-HD7V Service Manual

1-3-1. Camera Block Assembly

n
When replacing the camera block assembly, perform the adjustment of camera in reference to Section 2.
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the camera shield plate.
6. Disconnect the fan harness from the connector on the
DD-316 board.
7. Remove the screw (BSW M2 x 5), then remove the
earth cable.
8. Remove the Himeron tape (20 x 40) securing the
ferrite core.
9. Disconnect the coaxial harness from the connector
(CN403) on the VC-576 board.
10. Remove the three screws (PSW2.6 x 6), then remove
the camera block assembly.
11. Disconnect the fl exible fl at cable from the connector
(CN701) on the DD-316 board.
12. To install, reverse the removal procedure.
EVI-HD7V
Camera shield
VC-576 board
Camera block
assembly
Earth cable
BSW
M2 x 5
CN403
DD-316
board
PSW2.6 x 6
Fan harness
Coaxial
harness
CN701
Flexible
flat cable
Ferrite core
Himeron tape (20 x 40)
1-7