Board - Sony EVI-HD7V Service Manual

1-4-1. VC-576 Board
n
When replacing the VC-576 board, perform the adjustment of camera in reference to Section 2.
1. Remove the side cabinet. (Refer to Section 1-2-1.)
2. Remove the front bezel. (Refer to Section 1-2-2.)
3. Remove the camera cabinet (lower front/lower rear). (Refer to Section 1-2-3.)
4. Remove the camera cabinet (upper). (Refer to Section 1-2-4.)
5. Remove the DC fan. (Refer to Section 1-3-3.)
6. Remove the tape (A). (Refer to Fig. 1.)
7. Remove the Himeron tape (20 x 40) from the ferrite
core. (Refer to Fig. 1.)
8. Disconnect the two coaxial harnesses from the connec-
tors (CN102 and CN403) on the VC-576 board.
9. Remove the two screws.
10. Disconnect the FP-234 fl exible wiring board from the
connector (CN851) on the VC-576 board, then remove
the VC-576 board.
11. To install, reverse the removal procedure.
n
When attaching the FP-234 fl exible wiring board, place
it under the VC-576 board as shown in Fig. 2.
EVI-HD7V
BSW M2 x 5
VC-576 board
CN403
Fig. 1
Tape (A)
Ferrite core
Himeron tape (20 x 40)
Coaxial harness
CN102
CN851
Coaxial harness
FP-234 flexible
wiring board
Fig. 2
VC-576 board
FP-234 flexible
wiring board
1-11