3-3-13. Gear Block Assembly Replacement
Outline
Replacement
Manual eject drive removal
VH cleaner assembly removal
TC head assembly removal
Pulley gear (B) removal
Gear block assembly removal
Gear block assembly installation
Pulley gear (B) installation
Operation confirmation
TC head assembly installation
VH cleaner assembly installation
Manual eject drive installation
Preparations
1. Confirm that the unit is in the unthreading end state.
2. Turn off the power.
3. Remove the front lid and outside panel.
(Refer to section 1-6 in Part 1 of the Maintenance Manual.)
n
The gear block assembly can be replaced with the cassette compartment installed in
the unit.
Tools
. Torque screwdriver bit (for M1.4)
. Torque screwdriver (for 3 kg)
DNV-5
DNW-7/90/90WS
J-6325-110-A
J-6325-400-A
3-3-13. Gear Block Assembly Replacemen
3-71