Sony EVI-HD7V Service Manual page 51

m
. Perform "Hall Adjustment" (Section 2-3-1), "MR Adjustment" (Section 2-3-2) and "Image Sensor
Output 2ch Matching Adjustment" (Section 2-3-3) before this adjustment.
. Perform the adjustment with the lens in horizontal state.
. If reading/writing data on page 6F, set data:06 to page:0, address:10, and then select page F. By this data
setting, the page 6F can be selected.
After the data reading/writing fi nished, return the data on page:0, address:10 to "00".
. Check that the data of page:6, address:02 is "00". If not, select page:6, address:01, set data:00, and press
the PAUSE button.
Preparation
1. Install the fl ange back adjustment tool so that the
distance between it and the front of lens of camera is
less than 3 cm.
2. Make the height of fl ange back adjustment tool and the
camera equal.
3. Check that the center of Siemens star chart meets the
center of shot image screen with the zoom lens at
TELE end and WIDE end respectively.
Adjusting procedure
Order Page Address
1 0 01
2 6 4D
3 6 64
4 6 14
5 6 01
6
7 6 01
8 6 02
9 6 0C
10 0 10
11 F 57
(6F)
12 0 10
*1: The adjustment data will be automatically input to page:6F, address:11, 48 to 58.
Procedure after completing adjustment
Order Page Address
1 6 01
2 6 01
3 6 01
4 6 4D
5 6 64
6 0 10
7 0 01
8
EVI-HD7V
Data Operation
01
40
04
83
13 Press the PAUSE button.
Wait for 2 seconds.
27 Press the PAUSE button. (*1)
Check that the data changes to "01".
Check that the data is "00".
06
Check that the data is "00" to "09".
00
Data Operation
00 Press the PAUSE button.
25 Press the PAUSE button.
00 Press the PAUSE button.
00
00
06
00
Perform "Flange Back Check".
(Refer to Section 2-3-6 or 2-3-7.)
Flange back adjustment tool
3 cm or less
Camera
2-21