Sony EVI-HD7V Service Manual page 21

3. Place the unit with the bottom plate upward.
4. Remove the three tapes (A).
5. Remove the earth cable from the hole of chassis.
6. Remove the earth cable from the DIP SW cover.
7. Disconnect the coaxial harness from the connector
(CN1201) on the SY-359 board.
8. Disconnect the four fl exible fl at cables from the con-
nectors (CN1002 to CN1004, CN1007) on the SY-359
board.
9. Remove the six screws, then remove the SY-359 board.
10. Remove the S shield plate.
11. To install, reverse the removal procedure.
n
When installing the SY-359 board, be careful not to
pinch the fl exible fl at cable and harness.
EVI-HD7V
Earth cable
CN1003 CN1004
DIP SW cover
PSW2.6 x 6 (Large)
Tapes (A)
PSW2.6 x 6 (Large)
Flexible
flat cable
Earth
cable
Front side
of main unit
Hole of chassis
CN1201
CN1002
CN1007
SY-359 board
S shield plate
Tapes (A)
Coaxial cable
SY-359 board
Flexible
flat cables
1-15