Pan/Tilt Adjustment; Preparation - Sony EVI-HD7V Service Manual

2-4. Pan/Tilt Adjustment

2-4-1. Preparation

1. VISCA communication software
The pan and tilt adjustment and operation test are performed using VISCA communication. Install the
VISCA communication software in a personal computer and perform transmitting and receiving of VIS-
CA command between a personal computer and a camera.
2. Requirement condition of adjustment
Perform the adjustment and operation check in the following cases.
. Repair or replace the SY-359, MDR-34 or SE-987 board.
. Replace either a pan motor or a tilt motor.
. Remove or reassemble the mechanical block of a pan and tilt.
. Remove or reassemble the cabinet of activating block for a pan and tilt.
n
The motor may malfunction with a strong rattle when the power is turned on after the pan motor or tilt
motor is replaced and reassembled. To prevent this, send the following command from the VISCA com-
munication software before disassembling it. (The tilt motor may malfunction with rattling only by loos-
ening the shaft securing screw even when it is not replaced.)
. Transmission at 8101062213FF (Receiving of debug command enabled)
Commands of 9041FF and 9051FF are returned to Response Window.
. Transmission at 8101061F03FF (Receiving of adjustment command enabled)
Commands of 9041FF and 9051FF are returned to Response Window.
. Transmission at 8101060CFF (Clearing of hall sensor data)
Commands of 9041FF and 9051FF are returned to Response Window.
n
Perform the adjustment from Section 2-4-2 after reassembling the unit. And confi rm the fi rmware version
by sending the following command using communication software.
. Transmission at 81090002FF (Inquiry of model name and version)
Command of 90500001508pqrs02FF or 90500001509pqrs02FF is returned to Response Window.
"pqrs" represents the version number. (Example: 0101 = Ver. 1.01)
EVI-HD7V
2-45