Agilent Technologies 1290 User Manual page 55

3
When the outer pin is locked into the groove, manually
screw the nut onto the valve head.
N O T E
Fasten the nut manually. Do not use any tools.
5
Push the valve head until it snaps in and stays in the rear
position. (TCC only)
1290 Infinity TCC User Manual
4
Install all required capillary connections to the valve.
6
Power on or power-cycle your module, so the valve head
gets recognized during module initialization.
N O T E
Power Off the Infinity valve drive for at least 10 s.
Installing the Module
Installing Valve Heads
3
55