Operation; Starting Up The Projector; Adjusting The Projected Image - BenQ MX854UST User Manual

Operation

Starting up the projector

1. Plug the power cord into the projector and into a
wall socket. Turn on the wall socket switch
(where fitted). Check that the
indicator light
after power has been applied.
Please use the original accessories (e.g. power cable) only
with the device to avoid possible dangers such as electric
shock and fire.
2. Press
and a start up tone sounds. The
green when the projector is on.
The start up procedure takes about 30 seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to adjust the image clearness.
To turn off the ring tone, see
details.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
3. To use the O SD menus, please set them to
your familiar language first.
4. If you are prompted for a password, press the
arrow keys to enter a five digit password. See
"Utilizing the password function" on page 31
for details.
5. Switch all of the connected equipment on.
6. The projector will start to search for input
signals. The current input signal being scanned displays in the upper left corner of the
screen. If the projector doesn't detect a valid signal, the message '
continue displaying until an input signal is found.
You can also press
desired input signal. See
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen. Please change to an input signal
which is compatible with the projector's resolution or set the input signal to a lower setting. See
"T iming chart" on page 71
To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning
if off.

Adjusting the projected image

Adjusting the projection angle
The projector is equipped with 3 adjuster feet. These adjusters change the image height
and projection angle. To adjust the projector :
O peration
on the projector lights orange
PO W ER
on the projector
"Turning off the Power on/off ring tone" on page 45
SO U RCE
"Switching input signal" on page 33
for details.
POW ER
or remote control
POW ER indicator light
Please select language
on the projector or remote control to select your
to start the projector
flashes green and stays
for
Press Enter to confirm, Exit to leave
N o Signal
' will
for details.
25