BenQ MX854UST User Manual page 59

FU N CT IO N
Standby
Settings
N etwork
settings
Reset All
Settings
O peration
DESCRIPT IO N
N etwork
Enable N etwork Standby Mode
To enable or disable the network standby mode after the projector
is automatically or manually turned off.
• O n: The projector will maintain at network standby mode with
less than 6W power consumption.
• O ff: The projector will maintain at normal standby mode with
less than 0.5W power consumption.
Auto Disable N etwork standby mode
To enable or disable the auto switch from network standby mode to
non-network standby mode after a period of time. (This setting
should be grayed out when Enable network standby mode is off.)
• N ever:To disable the auto switch function. The projector will
maintain at network standby mode with less than 6W power
consumption.
• 20 min / 1 hr / 3 hr / 6 hr : The projector will be switched to
non-network standby mode after 20 minutes / 1 hour / 3 hours /
6 hours
Monitor Out
Selecting O n enables the function. The projector can output a VGA
signal when it is in standby mode and the CO MPUTER 1 jack is
correctly connected to devices. See
how to make the connection.
Audio Pass T hrough
The projector can play sound when it is in standby mode and the
corresponding jacks are correctly connected to devices. Press
to choose the source that you wish to use. See
22 for how to make the connection.
Enabling this function slightly increases the standby power
consumption.
MH L Charging
Selecting O n enable the function when device connected to
H D MI-1/MH L jack.
W ired LAN
AMX Device Discovery
AMX Device Discovery
W hen
detected by AMX controller.
MAC Address
D isplays the mac address for this projector.
Returns all settings to the factory preset values.
T he following settings will still remain: Position, Phase, H . Size,
Projector Installation, Language, H igh Altitude Mode, Security
Settings, Baud Rate.
"Connection" on page 22
"Connection" on page
O n
is , the projector can be
for
◄ ►
/
59