Table of Contents
Advertisement
354 Wheels and tyres
2
Position support
of jack
#
port point 1.
Turn ratchet
3
clockwise until support
#
sits completely on jack support point
the base of the jack lies evenly on the ground.
Turn ratchet
3
until the tyre is raised a maxi-
#
mum of 3 cm from the ground.
Loosen and remove the wheel (
#
Removing a wheel
Requirements:
The vehicle is raised (
R
* NOTE Mercedes-AMG vehicles
Observe the notes in the Supplement.
#
You could otherwise fail to recognise
dangers.
When changing a wheel, avoid applying any force
to the brake discs, as this could impair the level of
comfort when braking.
* NOTE Damage to the wheels' plastic ele-
ments when changing a wheel
4
on jack sup-
Plastic elements on wheels may be damaged
when removing and repositioning the wheel.
2
Do not raise the wheels by the plastic
#
1
and
elements when removing and reposition-
ing.
page 354).
/
* NOTE Damage to threading from dirt on
page 352).
/
#
#
#
#
#
wheel bolts
Do not place wheel bolts in sand or on a
dirty surface.
Unscrew the uppermost wheel bolt com-
pletely.
Screw centring pin
1
into the thread instead
of the wheel bolt.
Unscrew the remaining wheel bolts com-
pletely.
Remove the wheel.
Advertisement
Table of Contents
