How To Configure Cisco-Leap Advanced Security - NETGEAR WAG511 User Manual

User's Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511

How to Configure Cisco-LEAP Advanced Security

Follow the steps below to configure Cisco-LEAP.
1. Run the WAG511 Smart Wireless Wizard.
Make sure the WAG511 software is installed and the WAG511 is fully inserted in your PC.
a.
Open the configuration utility by clicking on the WAG511 icon
b.
desktop or in the system tray. The Settings tab page opens.
2. Configure the Network Name (SSID) settings.
Enter the SSID. This is also called the Wireless Network Name.
Tip: Click the Networks tab to view a list of the available wireless networks and their SSIDs.
Configure the Cisco-LEAP Advanced Security settings.
3.
Under Security, select the Advanced radio button then click Advanced Security.
a.
Figure 5-9: Cisco-LEAP settings screen
Select the Cisco-LEAP radio button.
b.
Fill in the User Name and Password.
c.
Click OK, then click Apply for the changes to take effect, and Close to exit the utility.
d.
4. Save your settings in a Profile.
5-16
202-10041-01 September 2004
on the Windows
Wireless Security Configuration