NETGEAR WAG511 User Manual page 27

User's Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Verify wireless connectivity to your network.
Verify that your Connection and Status Monitor information matches your wireless
a.
network.
Check the two LEDs on the WAG511:
b.
Table 3-1:
LED 1
Slow blink
Alternate
blink
Slow blink
Fast blink
OFF
Verify connectivity to the Internet or network resources.
c.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation section of
the Reference Manual on the NETGEAR Dual Band Wireless PC Card 32-bit CardBus
WAG511 Resource CD.
Basic Setup
LED Descriptions
LED 2 Meaning
OFF Power save mode (default from power up or reset)
Alternate Looking for network association
blink Power LED goes ON; Network LED is OFF; then Power
LED goes OFF and Network LED goes ON
Slow blink Associated or joined with network; no activity
Fast blink Associated or joined with network; blink rate increases
with activity on the network over the air or locally on the
network
OFF No power applied to the card
202-10041-01 September 2004
LED 2
LED 1
3-7