Table of Contents
Advertisement
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511V2H1
How to Configure WEP Encryption Security
Following the steps below to perform this procedure.
connecting to an access point.
1. Run the WG511V2H1 Configuration Utility.
Make sure the WG511V2H1 software is installed and the WG511V2H1 is fully inserted in an
a.
available CardBus slot in your PC.
Open the configuration utility by clicking on the WG511V2H1 icon
b.
system tray.
Figure 3-7: Security tab page
Click on the Configuration tab to display the view shown above.
c.
2. Configure the Security settings.
Check the Enable Encryption check box.
a.
3-30
in the Windows
Configuration
Advertisement
Table of Contents
