Wag511 Default Wireless Configuration Settings - NETGEAR WAG511 User Manual

User's Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511

WAG511 Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your WAG511 factory default basic settings are:
• Network Name Service Set Identification (SSID): Any (First available network)
Note: In order for the WAG511 Wireless PC Card to communicate with a wireless access point
or wireless adapter, all devices must be configured with the same wireless network name
(SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the WAG511 for basic wireless connectivity
to an access point. The procedures below provide step-by-step installation instructions for
Windows PCs. Use the procedure that corresponds to the version of Windows you are using.
Basic Setup
202-10041-01 September 2004
3-3