NETGEAR WAG511 User Manual page 44

User's Manual for the NETGEAR Dual Band Wireless PC Card 32-bit CardBus WAG511
Note: The channel number differs depending on the country. The connection speed
automatically defaults to the highest speed.
Click OK. The WAG511 will scan the area to determine which channel to use.
f.
Click Apply.
g.
3. Save your settings in a Profile.
Type a descriptive name in the "Profiles" field.
a.
Click Save Profile. All the configuration settings are saved in this profile.
b.
Click Apply.
c.
Click Close to exit the configuration utility.
d.
4. Verify wireless connectivity between your peer devices.
Verify connectivity by using the Ping program:
On the Windows taskbar click the Start button, and then click Run.
a.
Assuming the target PC is configured with 192.168.0.1 as its IP address, type
b.
192.168.0.1
This will cause a continuous ping to be sent to the device with the 192.168.0.1 static IP
c.
address. The ping response should change to "reply."
At this point the connection is established.
Note: If you cannot connect, see the
accessing network resources, the Windows Client and File and Print Sharing software might
not be installed and configured properly on your computers. Please refer to
Computers for TCP/IP Networking" on page
4-8
and then click OK.
"Troubleshooting" on page
202-10041-01 September 2004
3-13. Also, for problems with
C-1.
ping -t
"Preparing Your
Configuration