NETGEAR RP114 Reference Manual page 93

After defining filters in Menu 21, apply the filters to the Remote Node by entering the filter
number in Menu 11.5 - Remote Node Filters. You can cascade up to four filter sets by entering the
numbers of the desired filter sets, separated by commas and with no spaces between them.
Menu 11.5 - Remote Node Filters is shown in
Figure 8-5. Menu 11.5 - Remote Node Filters
Table 8-3 describes the fields of the Remote Node Filters display.
Table 8-3. Remote Node Filters Fields
Field Description
Input, Output, and These categories allow the application of filters to incoming data or outgoing data,
Call Filters and they cause or prevent the placement of outgoing calls.
Protocol Filters Enter the filter numbers of IP packet format filters defined in Menu 21.
Device Filters Enter the filter numbers of generic packet format filters defined in Menu 21.
For more information on using filters, refer to
Using the Manager Interface to Configure the Router for Internet Access
Reference Guide for the Model RP114 Web Safe Router
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters= 3
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=
Press ENTER to Confirm or ESC to Cancel:
Figure 8-5.
Chapter 10, "Configuring Filters."
8-9