NETGEAR RP114 Reference Manual page 98

Reference Guide for the Model RP114 Web Safe Router
Figure 8-8. Menu 12.1 - Edit IP Static Route
Enter settings for the static route entry.
3.
Table 8-5 lists and describes the fields for Menu 12.1 - Edit IP Static Route.
Table 8-5. Edit IP Static Route Fields
Field
Route Name
Active
Destination IP Address
IP Subnet Mask
Gateway IP Address
8-14
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:
Description
Enter a descriptive name for this route for identification purposes only.
Use this field to activate or deactivate this static route.
Enter the IP network address of the final destination. Routing is always based
on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Enter the subnet mask for this destination.
Enter the IP address of the gateway to the destination network. The gateway
is the next router that your router contacts in order to forward packets to the
destination. On the LAN, the gateway must be a router on the same segment
as the router. Over the WAN, the gateway will be the IP address of the router
at your ISP.
Using the Manager Interface to Configure the Router for Internet Access