Wan Setup - NETGEAR RP114 Reference Manual

WAN Setup

Menu 2 enables you to configure the 10 Mbps Ethernet port to a broadband modem device, such as
a cable or DSL modem. This port is labeled WAN on the front panel of the router.
Figure 7-3 shows Menu 2 - WAN Setup.
MAC Address:
Assigned By= Factory default
IP Address= N/A
Press ENTER to Confirm or ESC to cancel:
Figure 7-3. Menu 2 - WAN Setup
Table 7-3 lists and describes the fields for Menu 2 - WAN Setup.
Table 7-3. WAN Setup Fields
Field
MAC Address
Assigned By
IP Address
Using the Manager Interface for Initial Router Configuration
Reference Guide for the Model RP114 Web Safe Router
Menu 2 - WAN Setup
Description
The MAC Address is the 48-bit Ethernet address of the router's INTERNET port.
Set to Factory default to use the router's internal globally unique MAC address.
Set to 'IP address attached on LAN' to acquire and substitute the MAC address of
one of your PCs on the local network. Some ISPs will only accept traffic from the
MAC address of one PC. This feature allows your router to masquerade as that PC
by using its MAC address.
If you selected IP address attached on LAN in the previous field, you must specify
the IP address of the local PC with the MAC address to be used by the router.
7-7