Drive Belt; Belt Removal (Ebs) - Polaris RZR 900 2015 Service Manual

DRIVE BELT

BELT REMOVAL (EBS)

NOTE
Inspect the entire clutch outlet duct (including the outlet
duct screen) when replacing a drive belt. Remove any
debris found in the outlet duct or outlet duct screen
1. Remove the grease fitting on the left rear upper
control arm.
2. Remove the eight screws that retain the outer clutch
cover.
3. Maneuver the outer clutch cover outward as shown
below to access the drive belt.
NOTE
Removal of left rear wheel or left rear shock is NOT
necessary for belt replacement.
4. Mark the drive belt direction of rotation so that it can
be installed in the same direction.
9926814 R08 -
Manual
© Copyright Polaris Industries Inc.
5. Insert clutch spreader tool (2877408)
driven clutch as shown (tool included with vehicle's
tool kit).
q
.
Make sure the tool is square with the moveable sheave
6. Rotate tool towards the clutch to open the sheaves.
7. Walk the belt out of the driven clutch and drive clutch.
Remove the belt from the vehicle.
2015-2016 RZR 900
PVT SYSTEM
NOTE
surface of the driven clutch.
2016 RZR S 1000 Service
w
into the
5
5.11