Water Pump Housing Removal - Polaris RZR 900 2015 Service Manual

ENGINE / COOLING SYSTEM

WATER PUMP HOUSING REMOVAL

NOTE
The water pump housing can be serviced with the
engine installed in the chassis (see Chapter 3 – Water
Pump Removal, page
1. Remove the coolant lines from the thermostat
housing, cylinder inlet and oil cooler. Leave them all
attached to the water pump housing.
2. Remove the three long gold colored bolts
retaining the water pump housing to the engine.
9926814 R08 -
3.106
3. Remove the water pump assembly from the engine
by using a twisting motion as you pull out on the
housing.
).
4. If water pump service is required (impeller or
mechanical seal), refer to Water Pump Service,
page
q
2015-2016 RZR 900
.
2016 RZR S 1000 Service
© Copyright Polaris Industries Inc.
Manual