GE Corometrics 250cx Series Operator's Manual page 248

Question
How do I change the time?
How do I enable the maternal-only recorder
mode?
How do I turn off the recorder completely?
D-14
Frequently Asked Questions:
1. Rotate the Trim Knob to highlight the Setup legend at the bottom of the display,
below the menu bar.
2. Once the Setup legend is highlighted, press the Trim Knob.
3. The display changes to the General Setup screen.
4. In the General Setup screen, rotate the Trim Knob to highlight one of the Time:
setting fields on the top left corner of the display. These fields are for hours (HH),
minutes (MMM), and seconds (YYYY). Note that the seconds field cannot be
selected or set.
5. After the desired field is highlighted (selected), press the Trim Knob. The current
setting displays in blinking inverse video.
6. Now rotate the Trim Knob to change the current time parameter setting.
7. Once you set the desired value, press the Trim Knob again to save the value. The
current value setting stops blinking.
8. Repeat Step 4 through Step 7 for any other date parameters that need to be set.
9. Now rotate the Trim Knob to select (highlight) the Exit item on the bottom menu.
1. From the On state, (The yellow LED above the recorder is illuminated.), press the
Record button once quickly. The recorder advances, printing the date and time on
the chart paper perpendicular (rather than parallel) to the direction of paper travel.
Then the recorder halts and the yellow LED flashes intermittently to indicate
MATERNAL ONLY mode is enabled.
2. From the Off state, (The yellow LED above the recorder is off), press the Record
button twice quickly. The recorder advances, printing the date and time on the chart
paper perpendicular (rather than parallel) to the direction of paper travel. Then the
recorder halts and the yellow LED flashes intermittently to indicate MATERNAL
ONLY mode is enabled.
From the On or MATERNAL ONLY state, (The yellow LED above the recorder is
illuminated or flashing intermittently.), press Record and hold for 2 seconds, until the
monitor emits a two tone audio beep which indicates that the recorder is off. The yellow
LED is now extinguished.
250cx Series Maternal/Fetal Monitor
2036946-001
Answer
Revision C