GE Corometrics 250cx Series Operator's Manual page 138

Annotation
Remote annotation from a central information
system. For example:
EPIDURAL GIVEN.
AROM.
POS CHG LEFT SIDE.
HBC
or
→
|
|
|
|
→
11-12
Recorder Modes: Summary of Annotations
Summary of Annotations (Continued)
This annotation represents notes received from a remote central information
system. The computer icon prints in the bottom two lines of the top grid. The
icon marks the time of the annotation and also indicates that the information
comes from a remote computer such as a QS/Perinatal System. The notes print
on any lines except the first, (The first line is reserved from NIBP vital signs
data.)
This annotation prints on the first annotation line following the active heart rate
mode(s) indicating heartbeat coincidence is enabled. This feature is enabled/
disabled via the password-protected Install Options service screen. The
annotation represents only that the feature is enabled; it does not indicate that
heartbeat coincidence has been detected.
This annotation prints in the top two lines of the upper grid indicating that the
monitor detects heartbeat coincidence.
This annotation prints in the top two lines of the upper grid indicating the
cessation of heartbeat coincidence.
This annotation prints on the bottom two lines of the upper grid indicating that
active telemetry signals are being received. The annotation re-prints every 30
minutes along with the modes.
This annotation prints on the bottom two lines of the upper grid indicating that
telemetry signals are no longer being received.
This annotation can only be seen when dual heart rate monitoring is in progress.
←
The offset annotation
|
indicating that the secondary fetal heart rate trend is shifted +20 bpm. The right/
|
left arrows (→ ←)and vertical dashed lines bracketing the heart rate grid
|
indicate the start/end of the fetal heart rate offset mode, respectively.
|
←
This annotation prints on the bottom two lines of the upper grid indicating an
event. Generate the mark by one of the following:
Briefly press the monitor's Mark [Offset] button.
Press the FM Remote Marker button. (The Remote Marker is an accessory
that can be connected to the 250cx Series Monitor. The monitor can be
configured to use this arrow annotation or the one shown in the next row of
this table. Refer to the "250/250cx Series Monitor Service Manual".)
250cx Series Maternal/Fetal Monitor
2036946-001
Explanation
or prints at the top of the upper grid
Revision C