Advertisement
Use a General Electric 787 (6 volt, 10 watt) lamp or its
equivalent (Navitar part # 9-12126).
1. Turn the power switch off and allow the lamp to
cool before handling.
2. Loosen the cover lock screw two turns. Rotate the
cover counterclockwise and remove.
3. Remove the old lamp by pulling it straight up. Do
not twist the lamp or the glass envelope may
shatter.
4. Insert the new lamp carefully.
5. Remove any fingerprints from the lamp envelope.
6. Replace the cover and tighten the lock screw.
Always switch off the projector and unplug the
mains lead before replacing fuse!
To avoid the risk of fire, replace only with a fuse of
the same type and rating.
Fuses
Primary circuit: 1x2A slow blow for 220, 230 and 240v
or 1x4A slow blow for 120v.
Secondary circuit: 1x2A/26v slow blow. 1x1.25A/10v
slow blow.
The electric circuits in your projector are protected by
three fuses which you can replace yourself.
25
Advertisement
