Advertisement
14
Using the slide change button on your projector
Push the slide change button repeatedly to move the
tray forward or backward until it stops in the zero
position.
Using the Kodak Ektapro IR Remote System RA/LP
Press "0" on the remote control and confirm with the
enter key.
Using the power switch
Turn the projector off by the power switch. When the
projector is turned on again, it will complete a system
check and bring the slide tray back to the zero posi-
tion.
Using RS-232 Control
The slide tray can also be moved into the zero position
using RS-232.
In an emergency ( such as a transport failure), the tray
can be removed from the projector in any position.
1. First, switch off your projector!
2. Push aside the slide tray lock, located in the
center of the tray, and hold it while lifting off the
tray.
3. Turn the slide tray over and rotate the base plate
until it clicks into the zero position. Otherwise, the
slide tray cannot be replaced on the projector in
the zero position.
4. Turn the projector on again. The slide remaining in
the slide gate will be ejected by the slide lift and
can be replaced in the slide tray.
Advertisement
