Advertisement
If you are familiar with both the operation of a 35mm
slide projector and your video display, you may follow
an abbreviated start-up procedure.
Before starting, review the precautions on page 6.
To "Quick Start" the VideoMate 7500XY, proceed as
follows:
1. Check the voltage setting before powering on.
Make sure that the setting above the power cord is
correct for your voltage. In addition, the fuse
behind the voltage settings needs to be checked.
2. Plug the power cable into a suitable power supply.
3. Connect your TV monitor to the Composite Video
and/or Y/C (S-Video) or RGB/Sync output connec-
tor on the back panel of the VideoMate.
4. If genlocking, connect the external sync cable to
the external sync input port of the projector. Skip
to number 5 if you are not using genlock.
5. On the menu control panel, set the projector/
camera menu control switch to the projector
position. Make sure that the green LED is lit. (If
the yellow LED is lit, only the menu panel controls
will work.)
6. Load the slide tray onto the projector.
7. Turn on the TV monitor and the VideoMate power
switch.
8. Advance to the first slide.
9. Press the home position button to center the slide
on your screen.
10. Adjust the TV monitor controls and the iris and
focus controls on the control panel of the projector
to produce a suitable image.
Note: A very dark slide may require readjustment of
the iris, but a setting can usually be reached that
produces an acceptable display throughout a range of
slides.
11
Advertisement
