Advertisement
22
Changing the master pedestal
1. Set the " " to M. PED by pushing the MENU UP,
MENU DOWN buttons.
2. Set the master pedestal by pushing the DATA UP,
DATA DOWN buttons. The DATA UP button
increases the master pedestal and the DATA
DOWN button decreases it. The master pedestal
setting ranges from -50 to 50.
When DTL OUT ON is selected in the OPTION
menu, the display M. PED turns off automatically
and cannot be changed.
Additional equipment required
To use the genlock feature, a second video source, a
video switcher and the proper input/output cables are
required. We also strongly recommend the use of a
vector scope for the best possible results.
When an external sync signal is input, the display
mode changes from the factory set INT (internal sync)
to EXT (external sync) automatically.
SYNC screen for EXT:
— 5 SYNC –-
MODE
H PHASE
SC 0/180
SC PHASE
Please note that there is no factory setting for the
genlock data. Your external data may appear different
from what is shown here, however, adjusting the data is
done in exactly the same way.
Changing EXT Settings
To select the item you want to adjust, move the arrow
" " on the left side of the screen up and down by
pushing the MENU UP, MENU DOWN buttons. Once
you choose an item, you can change the setting by
pushing the DATA UP, DATA DOWN buttons.
EXT
00
0
00
Advertisement
