Advertisement
12
To install the VideoMate 7500XY, proceed as follows:
1. Check the voltage setting before powering on.
Make sure that the setting above the power cord is
correct for your voltage. Also, check the fuse
behind the voltage setting to make sure it is
correct for your country.
2. Plug in the power cable.
3. Connect the cable to your peripheral equipment
(TV monitor, video projector, etc.). The connection
for Composite Video or RBG/Sync is BNC and a
4-pin MiniDin forY/C (S-Video).
4. If genlocking, connect the external sync cable to
the external sync input port of the projector. Skip
to number 6 if you are not using genlock.
5. If genlocking, follow the procedure on page 22.
6. On the menu control panel, set the projector/
camera menu control switch to the projector
position. Make sure that the green LED is lit.
7. Load the slide tray and "power-up" all equipment.
8. Press the forward button to advance the first slide.
9. When the projector is powered-up, the factory
settings for focus and iris are in the auto gain and
auto white balance modes. See the camera set-up
section for optional settings procedure.
10. Press the zoom button to select the correct
picture size for your presentation.
11. Adjust the iris and focus to produce a satisfactory
image. These are toggle controls that change
+/- when the button is pushed down.
Advertisement
